Heatless curls are exactly what they sound like: you wrap your hair around a soft rod before bed and wake up with waves, no curling iron needed. It takes a couple of tries to get the hang of it, so here's what makes the difference.
Step 1: Get the dampness right
This is the most important part. Your hair should be about 80–90% dry: slightly damp to the touch, not wet. Hair that's too wet won't dry overnight and will come out limp; fully dry hair can work too, but the waves are usually softer.
If you like, add a little mousse or leave-in conditioner through the lengths for extra hold.
Step 2: Place the rod
- Brush your hair out so there are no tangles.
- Lay the middle of the rod across the top of your head, from front to back, so the two ends hang down on either side of your face.
- Clip it in place at the crown if you have a small clip, or just hold it while you start wrapping.
Step 3: Wrap
- Take a small section of hair from the front on one side and twist it around the rod, away from your face.
- Keep adding a little more hair to each new twist as you work down, like a loose French braid around the rod.
- When you reach the end of your hair, secure it to the rod with a scrunchie.
- Repeat on the other side.
Step 4: Sleep
The rod is soft, so you can sleep on your back or your side. If you're a restless sleeper, a loose scarf over the top helps keep everything in place.
Step 5: Unwrap and style
- Take off the scrunchies and gently unwind your hair from the rod.
- Don't brush the curls. Run your fingers through them to loosen them into waves.
- A little hairspray or a drop of hair oil on the ends helps them last.
Troubleshooting
- Still damp in the morning? Start with drier hair, or wrap earlier in the evening.
- Too tight or crimped? Use bigger sections and wrap a bit more loosely.
- Frizzy? Smooth each section before you wrap it, and avoid touching the curls too much once they're out.
- Short hair? Start wrapping lower, at chin level, and use smaller sections.
Quick answers
Do you do heatless curls on wet or dry hair?
Slightly damp, about 80–90% dry. Wet hair won't dry overnight and comes out limp; fully dry hair works too, but the waves are softer.
How long should you leave a heatless curling rod in?
At least 4–6 hours, or overnight. The waves set as your hair finishes drying, so leave the rod in until your hair is completely dry.
How do I make heatless curls last?
Work a little mousse or leave-in conditioner through before you wrap, don't brush the curls out, and finish with a light hairspray or a drop of oil on the ends.
Can I sleep on my side with a curling rod?
Yes. The rod is soft and padded. Secure the ends well with the scrunchies and add a loose scarf if you move a lot in your sleep.
Do heatless curls work on short hair?
The rod works best on medium to long hair. On shoulder-length hair, start wrapping lower and use smaller sections. Very short hair may not reach around the rod.
Why didn't my heatless curls work?
Usually the hair was too wet, the sections were too big, or the rod came out before the hair was fully dry. The troubleshooting list above covers each one.
Our Heatless Curling Set comes with a soft rod and two scrunchies. Find more morning tools on our Shower & Hair shelf.