Swapping a handheld shower head takes about five minutes and no tools. Here is how to fit a filtered shower head, choose a spray and keep it working well.
What you need
- Your new shower head and its washer
- A towel, to put in the tub so nothing gets chipped if you drop the old head
- Plumber's tape (optional, only if the connection drips)
Fitting it
- Turn the water off.
- Unscrew the old head from the hose, turning it anticlockwise.
- Check the washer. Make sure the rubber washer is sitting flat inside the new head's connector. It's what stops leaks.
- Screw the new head on by hand until it's snug. Don't use a wrench: overtightening can crack plastic threads.
- Flush the filter. Run the water for about a minute before your first shower, so any loose bits from the new filter wash out.
It fits hoses with a standard G1/2 (½ inch) connector. Check your hose end before you start.
Using it
- Turn the head to switch between the 3 spray modes.
- Use the pause button to stop the water while you lather or shave, then press it again to pick up at the same temperature.
If it drips
Unscrew the head, check the washer is in place and flat, and screw it back on. If it still drips, wrap the hose thread with two or three turns of plumber's tape, in the same direction as you screw the head on.
Looking after it
- Rub the soft nozzles with your thumb every week or two to clear limescale.
- Check the filter every couple of months. Change the filter media when the flow drops or it looks discoloured.
Make it a ritual
Our filtered shower head has a replaceable filter, 3 spray modes and a pause button. For hair without hot tools afterwards, see the shower that doesn't need heat.